Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Rear Headlight on the Ford Fusion North America

Model: Ford Fusion North America MK 2 - Years 2013-2020
Part: Tail light

In this guide, you will see how to remove and replace the rear headlight on the Ford Fusion North America in simple and quick steps. First, open the hood of your vehicle and start by unscrewing the plastic screw located at the back of the headlight; then, remove the carpet covering and unscrew the two mounting nuts using a 10 mm socket wrench, as shown in the video. At this point, disconnect the electrical connector for the bulbs to remove the headlight from the outside, replacing it with the new one by following the reverse procedure!

Updated on 23 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Headlight Bulb on the Ford Fusion North America?
How to Replace the Front Headlight Bulb on the Ford Fusion North America?
Ford Fusion North America (2013-2020 / MK 2) To replace the front headlight bulb on the Ford Fusion North America, open the hood to loosen the two screws that secure the headlight from the top. …
How to Replace the Front Bumper of the Ford Fusion North America
How to Replace the Front Bumper of the Ford Fusion North America
Ford Fusion North America (2013-2020 / MK 2) Today, in this video tutorial, you will see the instructions that will allow you to remove and replace the front bumper of the Ford Fusion North Amer…
How to Replace the Exterior Door Handle on the Ford Fusion North America
How to Replace the Exterior Door Handle on the Ford Fusion North America
Ford Fusion North America (2006-2012 / MK 1) In this brief and simple guide, discover how to remove and replace the exterior door handle on the front door of the Ford Fusion North America. First…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos