Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Exhaust Manifold Gasket

Model: Ford Fiesta Fiesta 4, Be91, MK 4, MK IV - Years 1996-2002
Part: Engine

A very important step before applying the new gasket is to clean its seating: you must clean both the cylinder head side and the manifold side to remove any dirt and deposits that could compromise the adhesion and therefore the sealing of the gasket. Once cleaning is complete, insert the new gasket aligning it with the dowel pins, then insert the exhaust manifold and tighten the fixing nuts using a torque wrench and following a cross-tightening pattern. After installation, start the engine and ensure there are no leaks.

Updated on 12 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Exhaust Manifold Gasket
Replacing the Exhaust Manifold Gasket
Ford Fiesta (1996-2002 / Fiesta 4, Be91, MK 4, MK IV) Thoroughly clean the gasket seating, removing any dirt and deposits from both the cylinder head and the manifold; then apply the new gasket, aligning…
Replacing the Exhaust Manifold Gasket
Replacing the Exhaust Manifold Gasket
Ford Fiesta (2002-2008 / Fiesta 5, MK 5, MK V) Before applying the new gasket, it is essential to clean the gasket seating thoroughly, both on the manifold side and the cylinder head side, to remo…
Replacing the Intake Manifold Gasket
Replacing the Intake Manifold Gasket
Ford Fiesta (1996-2002 / Fiesta 4, Be91, MK 4, MK IV) Before applying the new gasket to the intake manifold, thoroughly clean the gasket seating on both the cylinder head and manifold sides: remove any d…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos