Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Fit the Cylinder Head Gasket

Model: Ford Focus MK 2, Focus 2 - Years: 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011
Part: Engine

See other generations:
Video tutorial

This video tutorial shows how to fit new cylinder head gaskets to a Ford Focus. After checking the flatness of the cylinder head base with a thin plastic feeler gauge, carefully inspect and discard any old gaskets.

The cylinder head gasket is placed between the cylinders and the cylinder head to ensure that oil, combustion gases, and coolant do not mix or leak. Using a special tool, measure the thread of the cylinder head bolts.

Use a spanner to undo and remove the old bolts. Check the flatness of the cylinders with a digital gauge to detect any warping.

At this point, insert a new cylinder head gasket. After purchasing a new pack of ten cylinder head bolts, apply bolt grease from the kit to each bolt (as shown in the video) to prevent them from seizing.

Once each bolt is inserted into its housing, ensure they are tightened correctly.


Updated on 13 February 2026 by ScegliAuto


Related tutorials

Replacement of Rocker Cover Gasket
Replacement of Rocker Cover Gasket
Ford Focus (1998-2004 / MK 1) Once you have removed the rocker cover and taken off the old gasket, clean both the gasket seat under the cover and the contact surface on the cylind…
Replacement of the Rocker Cover Gasket
Replacement of the Rocker Cover Gasket
Ford Focus (2004-2011 / MK 2, Focus 2) It is essential, before installing the new gasket, to clean the seating area thoroughly, both on the cover side and the head side; in this particular…
Replacement of Cylinder Head Gasket
Replacement of Cylinder Head Gasket
Ford Focus (2004-2011 / MK 2, Focus 2) If there are signs of coolant boiling, the cause is likely a damaged cylinder head gasket. If you need to remove the cylinder head to replace the gas…

How to Open the Fuel Filler Flap in the Hyundai i30?

In this tutorial, you will learn how to open the fuel filler flap in the Hyundai i30, a very simple operation that follows the typical procedure of most vehicles. First, unlock the locks using the designated button on the remote, then open the driver's door, locate the release lever on the left side of the seat, and operate it. Next, move to the fuel filler flap, open it completely, unscrew the cap, and refuel as needed. To close the flap, simply press it gently.

Watch the video!


by ScegliAuto

More videos