Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to remove the rear taillight of the Ford Escape

Model: Ford Escape MK 3 - Years 2013-2019
Part: Tail light

Today's guide will show us how to disassemble and replace the rear taillight and its bulbs of the Ford Escape, in simple and quick steps. First, we open the rear hatch of the trunk and start unscrewing the fastening screws found on the back of the taillight; then we disconnect the electrical connector of the bulbs to remove it, as shown in the video. At this point, we remove and replace any faulty bulbs with new ones, replacing either the entire taillight; we reassemble and connect the rear light, finally checking its operation.

Posted on 6 May 2024 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Rear Headlight of a Ford Escape?
How to Remove the Rear Headlight of a Ford Escape?
Ford Escape (2013-2019 / MK 3) In this video tutorial, you will see how to remove the rear headlight of a Ford Escape, model years 2013 to 2016. Start by opening the trunk and loca…
How to Replace the Rear Headlight on a Ford Escape?
How to Replace the Rear Headlight on a Ford Escape?
Ford Escape (2008-2012 / MK 2) In this tutorial, you will see how to remove the rear headlight on a Ford Escape, a very simple and quick operation to perform if you need to replace…
How to disassemble the rear light and replace the stop lights of the Ford Kuga.
How to disassemble the rear light and replace the stop lights of the Ford Kuga.
Ford Escape (2013-2019 / MK 3) Below we will see the instructions that will allow us to disassemble and replace the rear light and its bulbs of the Ford Escape, but also of the Kug…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos