Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to deactivate the 4x4 traction of the Ford Escape

Model: Ford Escape MK 3 - Years 2013-2019
Part: Checks and maintenance

These short and simple steps will show us how to deactivate the 4x4 traction of the Ford Escape; however, it is recommended not to deactivate the all-wheel drive to avoid compromising the safety and stability of the vehicle during driving. First, lift the vehicle and start disconnecting the electrical connector of the 4x4 traction sensor; then proceed to modify the connector to permanently deactivate the all-wheel drive system, as shown in the video. At this point, restore the wiring if you want to re-enable the all-wheel drive, following the video until the end!

Posted on 24 May 2024 by ScegliAuto

Video tutorial

Related tutorials

Guide to the All-Wheel Drive Functionality of the Ford Escape
Guide to the All-Wheel Drive Functionality of the Ford Escape
Ford Escape (2013-2019 / MK 3) In this brief guide, you will find instructions that will allow you to use the 4x4 or 4WD all-wheel drive of the Ford Escape. This vehicle is equippe…
How does Ford's intelligent AWD and 4WD system work?
How does Ford's intelligent AWD and 4WD system work?
Ford Escape (2020-2026 / MK 4) We can see in this video how the intelligent AWD and 4WD system of Ford works, which we see here on an Escape, but works in the same way on all model…
How to Remove the Rear Headlight on a Ford Escape?
How to Remove the Rear Headlight on a Ford Escape?
Ford Escape (2013-2019 / MK 3) In this video, you can see how to remove the rear headlight on a Ford Escape, a very simple and quick operation to perform if you need to replace a b…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos