Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Holden
    3. :
  3. Colorado 7
    4. : How to change the oil and oil filter on your Holden Colorado

Holden Colorado 7 - Video tutorial

Model: Holden Colorado 7 MK 2 - Years 2011-2023
Part: Engine oil
Operation: How to change the oil and oil filter on your Holden Colorado

To replace the oil and the oil filter on the Holden Colorado, lift the car up front, unscrew the oil filler cap, with a 15 socket wrench unscrew the oil drain plug making it drain into a container ; while the oil drains we go to the upper part of the engine, with a 1/16 socket wrench we unscrew the oil filter holder, remove the filter from the filter holder, remove the gasket from the filter holder; take the new filter, place it in the filter holder, put the new gasket in the filter holder and screw it into its housing; screw the oil drain plug, insert a funnel in the oil filling hole, pour the liters of oil indicated by the manufacturer, when we are approximately at the indicated liters check the level with the dipstick (the level it must be checked the second time you remove the dipstick) and if the level is on the max notch the operation is finished otherwise top up.


Posted on 12 May 2023 by ScegliAuto

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos