Do it yourself
Frequently asked questions about cars and motorcycles

Installation of Front Suspension Spacers

Model: Honda Civic MK 6 - Years 1995-2001
Part: Accessory kit

Lift the vehicle on a jack (it is advisable to use a car stand for safety) and remove the wheel where the installation will take place. Unscrew the fastening bolts of the upper wishbone flange of the front suspension. Insert washers between the chassis and the flange to create a sort of spacer, then insert new bolts, which should be longer than the originals, and tighten them properly. Repeat the same process on the other side. After installation, it is recommended to have the alignment and camber of the tyres checked.

Updated on 4 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Honda Civic (2001-2006 / MK 7) Loosen the wheel nuts and lift the vehicle, securing it. Unscrew the bolts and remove the wheel. Unscrew and extract the retaining pins from the susp…
Honda Civic (1995-2001 / MK 6) Loosen the wheel nuts and lift the vehicle, securing it safely. Unscrew the bolts and remove the wheel. Support the driveshaft with a hydraulic jack,…
Honda Civic (1995-2001 / MK 6) Lift the vehicle with a jack at the wheel where you will perform the installation (it is recommended to use a car stand for safety) and remove the wh…

How to Open a Stuck Boot on the Peugeot 407?

On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open.

Watch the video!


by ScegliAuto

More videos