Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Honda
    3. :
  3. Civic
    4. : Fuel fill line replacement

Honda Civic - Video tutorial

Model: Honda Civic MK 7 - Years 2001-2006
Part: Petrol filter
Operation: Fuel fill line replacement

Raise the car on a lift, remove the left rear wheel and the relative plastic wheel arch: at this point it is possible to see the metal conduit that starts from the filler cap of the tank and is connected to three rubber sleeves. Therefore unscrew the fastening clamps of the rubber sleeves and unhook them from the relative iron pipe to which they are connected; unscrew the screws of the fixing bracket of the pipes themselves and, once the cap has been unscrewed, extract the pipes and replace them with the new ones, first housing the seat of the cap and then fixing the relative bracket. Reconnect the rubber hoses and tighten the relative fixing clamps. Finally, reassemble what was previously removed.


Posted on 4 July 2023 by ScegliAuto



Installation of shaped rubber mats
Honda Civic (2006-2012 / MK 8) The installation of the rubber mats shaped for the specific car model and with the raised edge, are extremely simple to install, i.e. they must only
Disassembly and replacement of the Honda Civic fuel pump
Honda Civic (2006-2012 / MK 8) Let's see in this guide the procedure that will allow us to disassemble and replace the fuel pump of the Honda Civic, in simple and quick steps. Firs
How to replace the fuel filter in the Honda Civic?
Honda Civic (2001-2006 / MK 7) In this tutorial, we can see how to replace the fuel filter in the Honda Civic, an extremely simple and fast operation. First of all, we open the fue

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos