Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installation of an Internal Lighting System

Model: Honda Civic MK 9 - Years: 2012, 2013, 2014, 2015
Part: Accessory kit

See other generations:
Video tutorial

This video shows how to install an internal lighting system on a Honda Civic. Using a star screwdriver, remove the glove compartment.

Also, remove the lower central panel located under the radio unit; to do this, unscrew the two fixing screws. Disconnect the connections behind the panel and tie the wiring to the holes in the instrument panel.

Thread the wiring through the central panel and the switch hole, then connect it to the 5-PIN connector. Now, after marking a trace, drill a 20 mm hole in the centre of the panel.

Remove any debris from drilling. Install the ring seal, the bracket, and the LED. Mount two more LEDs on the two small brackets.

Now install the right and left lights. Use a tie wrap to secure the wiring better.

Refit the central panel and restore the connections. Install the switch and reassemble the driver’s side panel.


Updated on 5 February 2026 by ScegliAuto


Related tutorials

Boot Liner Installation
Boot Liner Installation
Honda Civic (2006-2012 / MK 8) The following operation requires an installation time of six minutes and is easy to perform. Boot liners provide complete protection for the car boot…
Installation of Front Suspension Spacers
Installation of Front Suspension Spacers
Honda Civic (1995-2001 / MK 6) Lift the vehicle on a jack (it is advisable to use a car stand for safety) and remove the wheel where the installation will take place. Unscrew the f…
Camber Kit Installation Instructions
Camber Kit Installation Instructions
Honda Civic (1995-2001 / MK 6) Lift the vehicle with a jack at the wheel where you will perform the installation (it is recommended to use a car stand for safety) and remove the wh…

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos