Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the headlight bulb of the Hyundai I10.

Model: Hyundai I10 PA, MK 1 - Years 2007-2013
Part: Headlight bulb

Below are the instructions on how to disassemble and replace the headlight bulb of the Hyundai I10. First, open the hood of the car and start by removing the plastic cap located behind the headlight; then disconnect the electrical connector of the bulbs to remove the light from the optical group, as shown in the video. At this point, install the new low beam bulb, of the right type and with the same attachment (in this case, a new LED lamp is installed); check the operation of the bulb and finally secure the plastic cap.

Posted on 2 September 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Fog Light Bulb on a 2013 Hyundai I10
How to Replace the Front Fog Light Bulb on a 2013 Hyundai I10
Hyundai I10 (2013-2020 / IA, MK 2) Replacing the left fog light bulb on a Hyundai I10 involves a few simple steps that you can carry out independently. To replace the bulb, you need to…
How to Replace the Front Headlight Bulb on Hyundai I10
How to Replace the Front Headlight Bulb on Hyundai I10
Hyundai I10 (2013-2020 / IA, MK 2) To replace the front headlight bulb on the Hyundai I10, open the bonnet to access the engine compartment and rotate the protective cap at the rear of…
How do you replace the headlight bulb of the Hyundai I10?
How do you replace the headlight bulb of the Hyundai I10?
Hyundai I10 (2013-2020 / IA, MK 2) It will be possible to replace the front headlight bulb of the Hyundai I10 by opening the hood to gain access to the components inside the engine com…

Other guides you may be interested in

How to Open a Stuck Boot on the Peugeot 407?

On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open.

Watch the video!


by ScegliAuto

More videos