Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Hyundai
    3. :
  3. I10
    4. : How to replace the headlight bulb Hyundai I10

Hyundai I10 - Video tutorial

Model: Hyundai I10 MK 1, PA - Years 2007-2013
Part: Headlight bulb
Operation: How to replace the headlight bulb Hyundai I10

In this very simple video guide we will see how to remove the headlight bulb of a Hyundai I10. The disassembly operation takes a few minutes and is not complicated. So first we open the bonnet to locate the headlight bulb: we will see that there are two options; a disassemble the headlight or we are going to disassemble the side panel in order to remove the bulb. With the special plastic levers we will release the lighthouse, removing the support screws. At this point, once removed, disconnect the electrical connector and remove the cap to replace the bulb!


Posted on 13 December 2023 by ScegliAuto



How to replace the headlight bulb on Hyundai I10?
Hyundai I10 (2013-2020 / MK 2, IA) To be able to replace the headlight bulb of the Hyundai I10 you have to open the hood to access the engine compartment and turn the protective cap of
How to replace the front headlight bulb of the Hyundai i10.
Hyundai I10 (2013-2020 / MK 2, IA) Replacing the left front headlight bulb of the Hyundai I10 is a very simple operation, easily performed independently, thanks to our short video tuto
How to replace the front headlight bulb of the Hyundai I10?
Hyundai I10 (2013-2020 / MK 2, IA) For the replacement of the left front headlight bulb of a 2018 Hyundai I10, we first need to open the front hood and unscrew the screws located on th

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos