Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Car Radio and Add a Subwoofer

Model: Hyundai Elantra MK 6 - Years: 2015, 2016, 2017, 2018, 2019, 2020
Part: Car stereo

See other generations:
Video tutorial

The following video shows the procedure for removing the car radio from a Hyundai Elantra. Start from the bottom edge of the frame (as shown in the figure); using a screwdriver, pry firmly and begin to detach the frame; gently pull the side piece towards you until it is completely removed.

Perform the same operation on the other side. Once the frame is detached, you will see the clips that held it in place.

In the next step, locate and remove the six screws securing the black cover. Now, using your fingers, detach the cover by popping it off from both the top and bottom.

Before removing the head unit, you will need to remove four more screws securing it. Now disconnect the four wiring connections. At this point, visit www.hmaservice.com to find the installation diagram.

The video then shows a line converter that allows a set of RCA connections. One important thing to note: the diagram should be viewed from the perspective where the wires enter the wiring.

Now prepare the line converter by uncovering its wires from the casing. Connect the wires as shown in the video (if you have a small soldering iron, it's better; otherwise, use wire connectors as shown in the video).

Under the dashboard, where the clutch is, make a small pilot hole followed by a larger one to pass the wiring to connect to the battery. Use a rubber grommet to avoid damaging the wiring (or use silicone).


Updated on 5 February 2026 by ScegliAuto


Related tutorials

How to Change the Radio on Hyundai Elantra
How to Change the Radio on Hyundai Elantra
Hyundai Elantra (2015-2020 / MK 6) Do you want to replace the car radio in your Hyundai Elantra? To remove the car radio, you need to detach the trim panels fixed to the centre console…
Removing the Car Radio from a Hyundai Elantra
Hyundai Elantra (2006-2010 / MK 4, HD) What to do if your car radio is damaged? Here’s how to remove it from above the dashboard. Pry underneath the trim plastic (bottom side: detach it fr…
How to Reset the Car Radio in a Hyundai Elantra?
How to Reset the Car Radio in a Hyundai Elantra?
Hyundai Elantra (2015-2020 / MK 6) If you need to reset the car radio in your Hyundai Elantra but don't know where to start, this operation is simpler and quicker than you might think.…

Other guides you may be interested in

How to Extract the Spare Wheel from a Mercedes Vito

The spare wheel of a Mercedes Vito is located underneath the vehicle, just below the rear boot. This video demonstrates how to extract the wheel from its compartment. First, open the boot and locate the tools provided with the vehicle to release the wheel; these can be found in a compartment on the right side of the boot. As shown in the video, use the supplied screwdriver to remove the cover cap from the hole where you will insert the socket spanner; this hole is located beneath the rubber seal above the rear bumper. Insert the spanner and attach the extension to allow you to turn it and lower the wheel from under the floor. Finally, detach the pin that allowed the wheel to lower and proceed to extract it from under the vehicle.

Watch the video!


by ScegliAuto

More videos