Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to DIY Replace the Clutch on the Hyundai i10

Model: Hyundai I10 PA, MK 1 - Years: 2007, 2008, 2009, 2010, 2011, 2012, 2013
Part: Clutch

See other generations:
Video tutorial

On the Hyundai i10, replacing the clutch requires removing the gearbox. Place the Hyundai i10 on axle stands, disconnect the battery, and clear the space in the engine bay. Loosen the front wheel nuts, lift the vehicle, and remove the wheels.

Drain the gearbox oil if necessary and disconnect the gear linkage, sensors, brackets, and supports that prevent removal. Support the engine with a dedicated stand and remove the gearbox support.

Disconnect the drive shafts from the hub and the differential output, then carefully slide the gearbox out of the bell housing. With the flywheel secured, unscrew the pressure plate, remove the disc, and check the condition of the flywheel; clean the surfaces and align the new disc with a centring tool.

Fit the new pressure plate and torque to the manufacturer's specifications; replace the release bearing and check the guide. Reinstall the gearbox on the Hyundai i10, aligning the input shaft with the disc hub, refit the support and fasteners, reconnect the drive shafts, restore the linkages and wiring, then refill the gearbox oil to the specification.

If your Hyundai i10 uses a cable clutch, adjust the pedal play; if it’s hydraulic, bleed the system until the pedal feels normal. Finish with gear engagement tests, check for leaks, and verify clutch engagement during a short road test.


Posted on 24 June 2026 by ScegliAuto


Related tutorials

How to Adjust the Clutch Cable on the Hyundai I10
How to Adjust the Clutch Cable on the Hyundai I10
Hyundai I10 (2007-2013 / PA, MK 1) Below are the main instructions that will allow you to adjust the clutch cable on the Hyundai I10. First, open the bonnet of the vehicle and start lo…
How to Replace the Clutch Cable of the Hyundai i10
Hyundai I10 (2007-2013 / PA, MK 1) Below are the main steps that will allow you to remove and replace the clutch cable of the Hyundai i10, following these simple instructions. First, o…
How to Adjust the Clutch Pedal on Hyundai I10
Hyundai I10 (2007-2013 / PA, MK 1) In this video tutorial, you will see the main instructions for adjusting the clutch on a Hyundai I10, as well as on other models from the manufacture…

Other guides you may be interested in

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos