Do it yourself
Frequently asked questions about cars and motorcycles

How to Remove the Rear Light of the Jeep Compass mk2?

Model: Jeep Compass 552, MK 2 - Years 2016-2025
Part: Tail light

In this video tutorial, you can see how to remove the rear light of the Jeep Compass mk2, in case you need to replace one or more bulbs or the light itself. Start by opening the tailgate of the boot, remove the covers that hide the two internal screws and unscrew them; these are Torx T30 screws. Next, using a flat tool, preferably plastic to avoid damaging the bodywork, lever at the back of the light and disengage it from its housing. At this point, you can extract it, disconnect the connector, and proceed to replace the bulbs.

Updated on 27 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Jeep Compass (2006-2016 / MK 1, MK 49) Let’s look at how to remove the rear light on a Jeep Compass. In this video, see how to take off the light and replace the bulbs. Open the boot lid, …
Jeep Compass (2016-2025 / 552, MK 2) In order to safely remove one (or both) of the rear lights of your second generation Jeep Compass, you must follow the steps described in the followi…
Jeep Compass (2006-2016 / MK 1, MK 49) Before you start, open the tailgate of your Jeep Compass. Begin by unclipping and removing the clips that secure the rear light to the vehicle. Next,…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos