Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Reset the Maintenance Light on Jeep Compass

Model: Jeep Compass 552, MK 2 - Years 2016-2025
Part: Warning light – error code

To reset the "Service" light on a Jeep Compass, follow these simple instructions. Get in the car, close all the doors, press the brake pedal with your left foot, and turn on the ignition using the relevant button. While keeping the brake pedal pressed, use your right foot to fully press the accelerator pedal three times quickly. Then, release the brake pedal and turn off the ignition. Wait a few seconds and turn the ignition back on; if everything has been done correctly, the service light will have turned off.

Updated on 27 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Reset Service on Jeep Compass
Reset Service on Jeep Compass
Jeep Compass (2006-2016 / MK 1, MK 49) Reset the maintenance light on a Jeep Compass if it appears. This operation is very simple. Enter the vehicle and turn on the ignition with the key. …
How to Reset the Oil Change Light on a Jeep Compass
How to Reset the Oil Change Light on a Jeep Compass
Jeep Compass (2016-2025 / 552, MK 2) Before you can start, sit in the driver's seat of your Jeep Compass. Begin by activating the instrument cluster without starting the engine by pressi…
How to Replace the Front Headlight Bulb of a Jeep Compass
How to Replace the Front Headlight Bulb of a Jeep Compass
Jeep Compass (2006-2016 / MK 1, MK 49) Before you begin, open the front bonnet of your Jeep Compass. Start by disconnecting the electrical connector attached to the blown bulb, using a fla…

    Frequently Asked Questions

    • Compass 2016-2025 - What does the "RPM x1000" light indicate in the Jeep Compass? Read answer
    • Compass 2006-2016 - Why does the start and stop light come on in a Jeep Compass? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos