Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Remote Battery in the Jeep Renegade

Model: Jeep Renegade 520, MK 1, BU - Years 2014-2026
Part: Key

In today's video, see how to replace the battery in the remote for the Jeep Renegade. First, remove the metal key from the fob. Insert it into the second slot found in the casing until you can detach the cover. You can then access the battery compartment. Remove the exhausted unit and proceed to insert the new battery of the same type. Specifically, it is a CR 2032 3v, available at major physical and online stores. Test the remote, and if it works correctly, reassemble the unit as before.

Updated on 9 August 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Key Fob Battery of the Jeep Renegade?
How to Replace the Key Fob Battery of the Jeep Renegade?
Jeep Renegade (2014-2021 / ) To replace the key fob battery of the Jeep Renegade, lower the lever located at the back of the fob, just below the chrome cover. This will allow you…
How do you replace the battery of the Jeep Renegade remote control?
How do you replace the battery of the Jeep Renegade remote control?
Jeep Renegade (2014-2023 / ) To replace the battery of the Jeep Renegade remote control, you need to remove the key from the top of the device so that you can pry open its housin…
How do you replace the battery of the Jeep Renegade remote control?
How do you replace the battery of the Jeep Renegade remote control?
Jeep Renegade (2014-2026 / 520, MK 1, BU) The procedure for replacing the battery of the Jeep Renegade remote control is done by levering on the left side of the device: this way it will be p…

Other guides you may be interested in

    Frequently Asked Questions

    • Jeep Renegade 2014-2026 - Why is the electronic key no longer detected in the Jeep Renegade? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos