Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Land Rover
    3. :
  3. Range Rover
    4. : Removing the Range Rover Sport bumper

Land Rover Range Rover - Video tutorial

Model: Land Rover Range Rover MK 2 - Years 2012-2021
Part: Rear bumper
Operation: Removing the Range Rover Sport bumper

Today we will see how to remove the rear bumper of a Land Rover Range Rover Sport. First we open the boot lid and remove the rubber caps that cushion the closing of our tailgate: then we remove the clips and screws that we find on both sides of the fenders and remove the screws that we find in the lower part of the bumper. At this point we begin to gently unclip the bumper in the side parts and then in the back: then remove the light by unscrewing the torx screws and disconnect the electrical connector. So let's remove the bumper, like in the video!


Posted on 31 December 2023 by ScegliAuto



Land Rover Range Rover Sport radiator disassembly guide
Land Rover Range Rover (2012-2021 / MK 2) Let's see in this guide the steps that will allow us to disassemble and replace the cooling radiator of the Land Rover Range Rover Sport. First we op
How to set the time on a Range Rover Sport
Land Rover Range Rover (2012-2021 / MK 2) Before we can begin, we will have to go and sit in the driver's seat of our Range Rover Sport. Let's start by activating the on-board computer by pre
Land Rover Range Rover Sport Timing Belt Replacement Guide
Land Rover Range Rover (2012-2021 / MK 2) In this short guide we will see the main instructions on how to disassemble and replace the timing belt of the Land Rover Range Rover Sport. First of

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos