Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing Range Rover Evoque Door Handle

Model: Land Rover Evoque L538, MK 1 - Years: 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018
Part: Handle

See other generations:
Video tutorial

Open the car door, remove the cover (as shown in the video) using a flathead screwdriver. Once the cover is off, which should come off easily, use a T25 Torx key to remove the small screw that was hidden underneath.

At this point, disconnect the short part of the handle and, only later, remove the main handle by pulling it out, first disengaging one hook and then the other. To install the new handle, proceed in reverse order, fitting the long fixed part of the handle first, then the short movable part, and screw in the single screw into the door.


Updated on 19 April 2026 by ScegliAuto


Related tutorials

Removing Door Panel on Range Rover Evoque
Removing Door Panel on Range Rover Evoque
Land Rover Evoque (2011-2018 / L538, MK 1) In this video, you will see how to remove the door panel (driver's side) of the luxurious Range Rover Evoque SUV. First, remove the small plastic cov…
Removing the Rear Door Panel of a Range Rover Evoque
Removing the Rear Door Panel of a Range Rover Evoque
Land Rover Evoque (2011-2018 / L538, MK 1) In this video, see how to remove the rear door panel of a Range Rover Evoque by following these simple steps. First, open the rear door and use a T27…
How to Remove the Handle from a Land Rover Evoque
How to Remove the Handle from a Land Rover Evoque
Land Rover Evoque (2011-2018 / L538, MK 1) Before you can start, open the door of your Land Rover Range Rover Evoque. Begin by removing the screw cover that secures the handle using a small fl…

Other guides you may be interested in

How to Replace the Glow Plugs in the Fiat Ducato 2.3 Multijet?

Glow plugs, as the name suggests, raise the temperature of the engine in diesel vehicles to allow for easier starting. The manufacturer, in this case, Fiat for the Ducato 2.3 Multijet, specifies how often they should be replaced, and a warning light will illuminate when it's time. This work is carried out under the bonnet. First, remove the upper engine cover, then lift the coil and, using a socket wrench of the appropriate size, unscrew the glow plug to remove it from the base, followed by installing the new one.

Watch the video!


by ScegliAuto

More videos