Do it yourself
Frequently asked questions about cars and motorcycles

How to Remove the Radio and Monitor from a Land Rover Evoque

Model: Land Rover Evoque L538, MK 1 - Years 2011-2018
Part: Car stereo

In this video, we will see how to disassemble the entire infotainment system on the Land Rover Evoque; you will need a plastic trim tool and a couple of screwdrivers. Start by unscrewing the screws located on the sides of the center console: access them from the bottom sides, as shown in the video. Then, use the trim tool to pry off the console trim behind the gear shift, as it is simply held in place by clips. This will allow the entire console cover to come off easily; just disconnect the electrical connectors. Now the lower part of the radio will be exposed, so remove the screws holding it in place: simply slide it out and disconnect the electrical connectors. Next, unscrew the screws securing the dashboard to access the screen. There is one on each side, next to the radio; then remove the one securing the dashboard thickness on the passenger side. You will also need to unscrew the top of the steering column to access the screw holding the dashboard on the driver's side. Now the dashboard is free. Lift it with your hands and disconnect the electrical plugs; you can unscrew the monitor and disconnect the plugs. Operation complete.

Updated on 14 September 2026 by ScegliAuto

Video tutorial

Related tutorials

Land Rover Evoque (2011-2018 / L538, MK 1) If the AdBlue warning light is on in your Land Rover Evoque dashboard, it means the emissions fluid is at a too low level and needs to be refilled. T…
Land Rover Evoque (2011-2018 / L538, MK 1) This guide provides instructions to remove and replace the cabin air filter in the Land Rover Evoque. First, get inside the vehicle on the front pass…
Land Rover Evoque (2011-2018 / L538, MK 1) Replacing the gear knob in your first series Land Rover Evoque is really simple. To complete the operation in a few minutes, just read the following …

How to Open a Stuck Boot on the Peugeot 407?

On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open.

Watch the video!


by ScegliAuto

More videos