Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Lincoln
    3. :
  3. Aviator
    4. : How to replace the key remote control battery on a 2020 Lincoln Aviator

Lincoln Aviator - Video tutorial

Model: Lincoln Aviator MK 2 - Years 2020-2024
Operation: How to replace the key remote control battery on a 2020 Lincoln Aviator

The steps to perform a 2020 Lincoln Aviator car key remote control battery replacement are very simple. Before starting, let's make sure that we have the necessary material available and therefore a small flat-tip screwdriver and the correct model of the new 3V CR 2450 flat type battery. We take the remote control of our car, press the button located at the upper end of the same and thus extract the metal key. At this point, using the tip of the key, we lever the upper edge of the body (short side) and thus obtain the opening of the same; We then proceed to replace the battery by extracting the old one with the help of the flat tip of a small screwdriver. Finally we insert the new battery and close the body.


Posted on 10 September 2022 by ScegliAuto

    Frequently Asked Questions

    • Aviator 2020-2027 - What problems with the rough idle on the Lincoln Aviator? Read Answer
    • Aviator 2020-2027 - What vibration problems on the Lincoln Aviator? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos