Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To disassemble and clean the mixer on the Malaguti Fifty Top, first secure the motorcycle in a safe, immobilised position. This precaution is necessary to ensure the operator's safety and should be taken whenever maintenance operations are to be performed. Next, unscrew the bolts that secure the element covering the fuel mixer and remove it. Spray it with petrol and clean it with a cloth. Unscrew the 2 screws that secure the element with the fuel pipe connectors. Carefully clean the connectors (as seen in the images) and all accessible elements, as well as the remaining part. Finally, reassemble everything by retracing the steps shown in the video.

Updated on 7 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Disassembly and Cleaning of the Mixer on a Malaguti Fifty Top
Disassembly and Cleaning of the Mixer on a Malaguti Fifty Top
Fifty Top First, position the scooter in a stable and secure manner so you can work safely. After removing the engine cover, start by disconnecting the two tub…
How to Remove the Engine Block of the Malaguti Fifty Top
How to Remove the Engine Block of the Malaguti Fifty Top
Fifty Top Below are the steps to remove the entire engine block from the frame of the Malaguti Fifty Top, following the instructions provided. First, place the…
How do you replace the fork on the Malaguti Fifty Top?
How do you replace the fork on the Malaguti Fifty Top?
Fifty Top To replace the fork on the Malaguti Fifty Top, you need to loosen the screws that secure the front wheel to its housing. It will also be necessary to…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos