Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installation of iPhone Adapter Accessory Kit

Model: Mazda Mx 5 MK 1 - Years 1989-1997
Part: Accessory kit

Using the appropriate tools that fit into the slots above and below the car radio to release the retaining springs, remove the complete console and disconnect the necessary electrical wiring connectors to install the kit. Carefully remove the car radio by lifting it to allow disconnection of the connectors at the back. Use the adapter kit to install the iPod. Reinstall the car radio by reversing the previous steps. Route the connection cable behind the passenger glove compartment and then into the centre tunnel. Connect the phone to the accessory and check all functions offered by the new installation.

Updated on 7 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Installation of iPod, iPhone, iPad, MP3 and AUX Devices
Installation of iPod, iPhone, iPad, MP3 and AUX Devices
Mazda Mx 5 (2005-2015 / MK 3, NC) The following guide shows the installation of devices such as iPhone, iPod, iPad, and MP3 to your car radio. One solution for this operation is to in…
Installation of Front and Rear Bumper Spoilers
Installation of Front and Rear Bumper Spoilers
Mazda Mx 5 (1989-1997 / MK 1) Lift the vehicle on suitable car stands or a lift to facilitate the installation process. The spoiler kit includes the securing screws: you will need…
Emergency Tyre Repair Kit for a Mazda MX-5 RF
Emergency Tyre Repair Kit for a Mazda MX-5 RF
Mazda Mx 5 (2015-2024 / MK 4, ND) The video shows what the emergency tyre repair kit for a Mazda MX-5 RF contains. It is to be used for puncture repairs up to a maximum size of 4 mm. …

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos