Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Kit for Modifying the Engine Air Intake

Model: Mazda 6 MK 1, GG - Years 2002-2008
Part: Accessory kit

To perform the modification, you need to obtain the complete kit. Start by disconnecting the negative terminal of the battery, then disconnect the connector of the sensor located on the air duct. Completely remove the air filter box by detaching all connected hoses, then take it out of the engine bay. Prepare the new accessory by carefully following the attached instructions. Insert the new filter support in place of the old box and connect the various hoses. Insert the sensor into its new housing and secure it with screws. Install the new air filter, reconnect the sensor, and reactivate the battery. Conduct a test to verify the vehicle's performance.

Updated on 8 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to remove the driver's side vent on Mazda 6
Mazda 6 (2002-2008 / MK 1, GG) Do we want to replace the side air vents on a Mazda 6? We disassemble the vents to perform the replacement. We leverage the upper and lower part with…
How to Remove the Front Bumper Grille of a Mazda 6
How to Remove the Front Bumper Grille of a Mazda 6
Mazda 6 (2002-2008 / MK 1, GG) Do you want to replace the front bumper of a Mazda 6? Let's see how to proceed. Lift the bonnet and secure it. Using a plastic spatula or screwdriver…
How to Replace the PVC Valve on a Mazda 6
How to Replace the PVC Valve on a Mazda 6
Mazda 6 (2002-2008 / MK 1, GG) Let's see how to remove and replace the PVC valves on a Mazda. Lift the car on a column lift to your preferred height. Unscrew the oil drain plug. In…

Other guides you may be interested in

How to Replace the Cabin Fan Resistor on a BMW 3 Series

How to Replace the Cabin Fan Resistor on a BMW 3 Series. Open the door and remove the plastic cover under the dashboard on the right side. Use a trim tool to pry off the cover next to the dashboard. Get a screwdriver or a cordless drill, open the glove compartment, and unscrew the fastening screws around the perimeter with a screwdriver. Once this is done, pull out the glove compartment and disconnect the power cables. Remove the fan resistor from its housing, insert the new part into the filter holder, and reassemble all the components of the glove compartment as you disassembled them earlier.

Watch the video!


by ScegliAuto

More videos