Do it yourself
| ||||
|
Mazda 6 - Video tutorial
Model: Mazda 6
GG, MK 1
- Years 2002-2008 Let's see together how to disassemble and replace the PVC valves of a Mazda. We lift the car on a column bridge and place it at the preferred height. We unscrew the pin for oil leakage from the In the engine compartment we disconnect the battery clamps, the clamps from the pipes in the engine seats, we remove the air filter kit in such a way as to get to disassemble the throttle body. Disassemble the plastic panel on the engine head and remove the oil rod. We use a vacuum cleaner to get rid of any dirt debris that is harmful to our engine. We disconnect the power supply terminals and unscrew all the pins of the smoke purge block and remove it out of the engine compartment. We disassemble the PVC valves with a screwdriver and mount the new ones. Now let's get ready to assemble the block following all the pins in the right seats, then, carefully clean the valve attached to it and reassemble it with the suitable gasket. We tighten the pins with a suitable socket wrench and reconnect all power plugs and sleeve clamps. Let's remember the assembly of the air box.
Posted on 28 September 2023 by ScegliAuto
How to change the thermostatic valve on the Mazda 6 2.0 MK1
Mazda 6 (2002-2008 / GG, MK 1) In this video tutorial we will see how to remove and replace the thermostatic valve on the Mazda 6 2.0 Diesel, first series, in simple and quick step
How to change the solenoid purge valve on a Mazda-6
Mazda 6 (2002-2008 / GG, MK 1) Let's see together how to disassemble and replace the solenoid purge valve of a Mazda-6. Let's open the bonnet, lift it and put it in safety. We deta
How to disassemble the EGR valve on Mazda 6 3.0 V6
Mazda 6 (2002-2008 / GG, MK 1) In today's video tutorial we will see the instructions to disassemble and replace the EGR valve on a Mazda 6 3.0 six-cylinder diesel, first series. F Other guides that may interest you
|
How to reset the oil service in the Fiat Toro?In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.109
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |