Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mazda
    3. :
  3. 6
    4. : How to disassemble the pulse generator on a Mazda 6

Mazda 6 - Video tutorial

Model: Mazda 6 GG, MK 1 - Years 2002-2008
Part: Valve
Operation: How to disassemble the pulse generator on a Mazda 6

Let's see in this video how to go and intervene on the disassembly of a pulse generator of a Mazda. First we loosen the wheel pins with a telescopic wrench, then, we lift the car on a column bridge and remove the rim. With a screwdriver unscrew the stone guard placed under the side mudguard and remove it. We will find our sensor (we unscrew the two locking pins), with a socket wrench we can unscrew the locking pins. We detach the piece from the engine seat. We compare the worn piece with the new one, mount the piece with the respective locking pins, screw the stone guard and the wheel back on. Finally we bring the car back to the ground.


Posted on 30 September 2023 by ScegliAuto



How to replace the cabin filter of the Mazda 6 2018
Mazda 6 (2012-2023 / GJ, MK 3) If you want to replace the air filter inside the cabin of your Mazda 6 (2018), you just need to follow the steps described in this new mini guide ded
Replacement of the timing belt of the Mazda 6.
Mazda 6 (2008-2012 / GH, MK 2) Today's guide will show us how to disassemble and replace the timing belt of the Mazda 6, following the instructions below. First, we open the engine
How to disassemble the EGR valve on Mazda 6 3.0 V6
Mazda 6 (2002-2008 / GG, MK 1) In today's video tutorial we will see the instructions to disassemble and replace the EGR valve on a Mazda 6 3.0 six-cylinder diesel, first series. F

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos