Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Aftermarket Car Radio Installation

Model: Mazda Mx 5 MK 3, NC - Years 2005-2015
Part: Car stereo

To install a new aftermarket car radio, you must first remove the factory radio. Start by removing the plastic cover of the reinforcement plate located under the steering column, near the knees; then remove this plate and the side plastic covers that conceal the centre console. Next, unscrew the screws securing the centre console, which includes the radio and climate control buttons; pull the console forward, disconnecting the connectors to place it on a workbench. Separate the climate control buttons and attach them to the fitting panel to secure the new radio.

Updated on 10 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Installing Aftermarket Car Radio
Installing Aftermarket Car Radio
Mazda Mx 5 (1998-2005 / NB, MK 2) To install the new car radio, you first need to remove the factory unit: remove the plastic trim on the sides of the radio and insert the appropriate…
Installation of iPhone Adapter Accessory Kit
Installation of iPhone Adapter Accessory Kit
Mazda Mx 5 (1989-1997 / MK 1) Using the appropriate tools that fit into the slots above and below the car radio to release the retaining springs, remove the complete console and d…
Installation of iPod, iPhone, iPad, MP3 and AUX Devices
Installation of iPod, iPhone, iPad, MP3 and AUX Devices
Mazda Mx 5 (2005-2015 / MK 3, NC) The following guide shows the installation of devices such as iPhone, iPod, iPad, and MP3 to your car radio. One solution for this operation is to in…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos