Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mazda
    3. :
  3. Mx 5
    4. : Timing belt replacement

Mazda Mx 5 - Video tutorial

Model: Mazda Mx 5 NB, MK 2 - Years 1998-2005
Part: Timing belt
Operation: Timing belt replacement

It is advisable to carry out this maintenance only if you have good knowledge of general mechanics since a trivial error in the positioning of the belt could seriously compromise the functioning of the engine. Start by removing the part of the wiring located in front of the timing system cover, remove the auxiliary belt by loosening the tensioner of the power steering pump or alternator; drain the coolant and disconnect the sleeves of the thermostatic valve and the water pump; then remove the tappet cover and the timing cover; rotate the crankshaft pulley until the timing references are aligned; therefore disassemble the crankshaft pulley, the tensioner and idler bearings, the water pump and remove the toothed belt; then proceed with the installation of the timing kit which, in addition to the belt, includes the water pump, the tensioner and the idler.


Posted on 31 July 2023 by ScegliAuto



Timing belt replacement
Mazda Mx 5 (1998-2005 / NB, MK 2) It is advisable to carry out this maintenance only if you have good knowledge of mechanics: an error in the positioning of the toothed belt and some
Idle adjustment and timing
Mazda Mx 5 (1998-2005 / NB, MK 2) Adjusting the idle speed and timing are absolutely essential for the engine to operate at its best performance. Generally, the idle speed should run
Battery replacement for Mazda MX-5
Mazda Mx 5 (1998-2005 / NB, MK 2) Today we will see the step-by-step instructions that will allow us to disassemble and replace the battery of the Mazda MX-5, in simple and quick step

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos