Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Battery in a Mazda 2

Model: Mazda 2 DE, MK 2, DH - Years 2007-2014
Part: Battery

If you notice difficulties starting your vehicle due to a low battery charge, follow the procedure below to safely replace the battery. After opening the bonnet, locate the battery on the left side. First, disconnect the negative terminal, then disconnect the positive terminal. Remove the upper plate by unscrewing the nuts on top. Take out the old battery and replace it with the new one. Reconnect the negative terminal first, then the positive terminal, and finally refit the upper plate.

Updated on 1 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the remote battery for the Mazda 2?
How to replace the remote battery for the Mazda 2?
Mazda 2 (2014-2023 / MK 3, DJ) Replacing the remote battery for the Mazda 2, as shown in this tutorial, is an extremely simple and quick operation. You will only need a replacement…
How to replace the battery of the Mazda key
How to replace the battery of the Mazda key
Mazda 2 (2007-2014 / DE, MK 2, DH) The key fob on Mazda vehicles is very similar for all models from the same manufacturer, which means that replacing the key fob battery follows the s…
How to replace the battery of the Mazda 2 car remote control
How to replace the battery of the Mazda 2 car remote control
Mazda 2 (2007-2014 / DE, MK 2, DH) Today we will see how to replace the battery of the remote control of a Mazda 2 vehicle. To perform the replacement, we need to get a CR 16 20 model …

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos