Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of Engine Air Filter

Model: Mazda Cx 7 MK 1 - Years 2006-2012
Part: Air filter

Replacing the engine air filter is very simple: once the front bonnet is opened, the filter housing (air box) is located at the front right of the engine compartment (when facing forward). Disconnect the mass air flow sensor connector (MAF), the corresponding hose, and unclip the clips securing the cover of the housing. Then, remove the old filter, ensuring no dirt falls into the intake duct, and insert the new filter, making sure the seals adhere correctly to the edges. Reposition the cover, close the clips, and reconnect the hose and MAF connector.

Updated on 15 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing Number Plate Bulbs
Replacing Number Plate Bulbs
Mazda Cx 7 (2006-2012 / MK 1) Replacing the number plate bulbs is very simple and does not require removing any trim. Open the rear bonnet to access the bulb holder more easily. P…
How and when to replace the timing chain of the Mazda CX-7 2.3
How and when to replace the timing chain of the Mazda CX-7 2.3
Mazda Cx 7 (2006-2012 / MK 1) In this guide, we will see the main instructions that will allow us to disassemble and replace the timing chain of the Mazda CX-7 2.3; the timing cha…
How to Replace the Timing Chain on a Mazda CX-7
How to Replace the Timing Chain on a Mazda CX-7
Mazda Cx 7 (2006-2012 / MK 1) This video shows how to replace the timing chain on a Mazda CX-7. It should be replaced approximately every 62,000 miles. First, disconnect the batte…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos