Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the rear taillight bulbs of the Mazda CX-7

Model: Mazda Cx 7 MK 1 - Years 2006-2012
Part: Tail light bulb

These short and simple instructions will guide us through the process of disassembling and replacing the rear light bulbs of the Mazda CX-7. First, we open the rear trunk door and start removing the plastic cover located behind the taillight; then we remove the socket holder along with the bulb to be replaced, as shown in the video. At this point, we install the new stop bulb, of the correct type and with the same socket; we check its operation before reassembling everything, finally fixing the plastic cover!

Posted on 1 June 2024 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the Interior Light Bulb
Replacement of the Interior Light Bulb
Mazda Cx 7 (2006-2012 / MK 1) To replace the bulbs in the interior light, you need to remove the light fixture itself. Use a plastic lever to detach the fixture from the headlinin…
Replacing the Rear Brake Light Bulb
Replacing the Rear Brake Light Bulb
Mazda Cx 7 (2006-2012 / MK 1) To replace the brake bulb in the rear light, you do not need to remove the light unit as you can access the back of the light by opening the boot. Re…
How to Replace the Front Headlamp Bulb on the Mazda CX-7?
How to Replace the Front Headlamp Bulb on the Mazda CX-7?
Mazda Cx 7 (2006-2012 / MK 1) To replace the front headlamp bulb on the Mazda CX-7, remove the rivets located inside the wheel arch corresponding to the headlamp that needs the bu…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos