Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installing LED Rear Light Bulbs

Model: Mazda Cx 7 MK 1 - Years 2006-2012
Part: Light bulb

Replacing the rear light bulbs with LED types will give the vehicle a more modern and appealing look. To perform this operation, you do not need to dismantle the light; simply open the boot and remove the plastic cap located directly in front of the light holder to access it. Then, release the holder by turning it anti-clockwise and pull out the original bulb. Insert the LED bulb, ensuring it lights up (if not, rotate it 180 degrees) and reinstall the holder.

Updated on 18 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Guide to Replacing the Rear Light Bulbs on the Mazda CX-7
Guide to Replacing the Rear Light Bulbs on the Mazda CX-7
Mazda Cx 7 (2006-2012 / MK 1) In this brief and simple guide, learn how to remove and replace the rear light and its bulbs on the Mazda CX-7. First, open the rear hatch of the boo…
How to replace the rear taillight bulbs of the Mazda CX-7
How to replace the rear taillight bulbs of the Mazda CX-7
Mazda Cx 7 (2006-2012 / MK 1) These short and simple instructions will guide us through the process of disassembling and replacing the rear light bulbs of the Mazda CX-7. First, w…
Replacing Rear Headlamp Bulbs
Replacing Rear Headlamp Bulbs
Mazda Cx 7 (2006-2012 / MK 1) Replacing the rear headlamp bulbs is very simple as it is not necessary to remove the headlamp; you can access the bulb holder from the boot by remov…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos