Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Classe C
    4. : How do you replace the starter motor on the Mercedes C-Class?

Mercedes Classe C - Video tutorial

Model: Mercedes Classe C W203 - Years 2000-2007
Part: Starter motor
Operation: How do you replace the starter motor on the Mercedes C-Class?

To be able to replace the starter motor of the Mercedes C-Class you need to access the lower part of the engine compartment of the car: the motor will in fact be found in correspondence with the axle shaft of the left front wheel, in the part between the engine block and the transmission. Once it has been identified, it will be possible to disconnect its main connector by unscrewing the screws that fix it to its support. Then you can disconnect all the other connectors, insert a new spare part, connect it and verify that everything works correctly.


Posted on 11 December 2022 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Classe C 2007-2013 - Where is the starter motor located in the Mercedes C-Class W204? Read Answer
    • Classe C 2007-2013 - Where is the starter located on Mercedes C180? Read Answer
    • Classe C 2000-2007 - Where is the starter on the Mercedes C-Class located? Read Answer
    • Classe C 2007-2013 - Where is the starter motor of the Mercedes C-Class W204? Read Answer
    • Classe C 2000-2007 - Where is the starter motor of the Mercedes C-Class W203 located? Read Answer
    • Classe C 2000-2007 - Position of the starter motor of the Mercedes C-Class? Read Answer
    • Classe C 2014-2021 - What is the position of the starter on the Mercedes c200? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos