Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installation of Aftermarket Car Radio

Model: Mercedes Sprinter MK 2, W906 - Years 2006-2018
Part: Car stereo

To install a new car radio, you must first remove the factory unit: before disconnecting it, ensure you have the security code, which is essential for reactivation. Detach the trim around the radio and climate control by disconnecting the parking indicator plug; then unscrew the radio's mounting screws by removing the glove compartment and pull the radio out of its slot, disconnecting the relevant plugs; use the adapter wiring to connect the new radio and take power from the cigarette lighter to allow the radio to turn off automatically when the ignition key is removed; secure the radio in its place and reattach the trim.

Updated on 15 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Alternator Replacement Instructions
Mercedes Sprinter (1995-2006 / MK 1, W901) To remove the alternator, it is easier to access from underneath, so lift the vehicle on a ramp. Disconnect the cables and the connector attached to …
Replacing the Car Steering Wheel
Replacing the Car Steering Wheel
Mercedes Sprinter (2006-2018 / MK 2, W906) The steering wheel is one of the most important and solid parts of the car, so it is rarely replaced. However, if this happens, it is advisable to do…
Where are the Fuses in the Mercedes Sprinter?
Where are the Fuses in the Mercedes Sprinter?
Mercedes Sprinter (2006-2018 / MK 2, W906) Any fuse in the Mercedes Sprinter is located inside one of the two fuse boxes installed in the vehicle, both of which are found within the cabin. The…

Other guides you may be interested in

How to Open a Stuck Boot on the Peugeot 407?

On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open.

Watch the video!


by ScegliAuto

More videos