Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Classe B
    4. : Disassembly and replacement of the rear headlight bulbs of the Mercedes B-Class.

Mercedes Classe B - Video tutorial

Model: Mercedes Classe B MK 1, W245 - Years 2005-2011
Part: Rear light bulb
Operation: Disassembly and replacement of the rear headlight bulbs of the Mercedes B-Class.

In this video tutorial, we will see how to disassemble and replace the bulbs of the rear headlight of the Mercedes B-Class, following these simple steps. First, we open the rear trunk door and start removing the plastic side cover, thus accessing the back part of the light; then, we disconnect the electrical connector of the ceiling light, where all the bulbs are connected, as shown in the video. At this point, we replace the damaged bulbs with new ones, unscrewing the screw of the light if we want to remove it and replace it with the new one!


Posted on 12 May 2023 by ScegliAuto



How to replace the headlight bulbs of a Mercedes B-Class
Mercedes Classe B (2005-2011 / MK 1, W245) How to replace the headlight bulbs of a Mercedes Class B. We open the front hood by pulling the lever located at the bottom right of the dashboard, l
How to remove a light bulb on a Mercedes B-Class headlight
Mercedes Classe B (2005-2011 / MK 1, W245) How to remove / install a bulb on a headlight of your Mercedes B-Class? Let's see immediately in this video how to do it in the best way. We open the
How to replace the headlight of the Mercedes B-Class
Mercedes Classe B (2005-2011 / MK 1, W245) To prevent any problems on the electrical circuit, it is necessary to unhook the hood from the special lever to be able to lift it and fix it with th

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos