Do it yourself
| ||||
|
Mercedes Classe S - Video tutorial
Model: Mercedes Classe S
MK 3, W140
- Years 1991-1998 The following guide shows you step by step how to best replace the brake discs in your car. These are of primary importance so that your vehicle always maintains maximum efficiency, both for the safety of the driver and passengers. This procedure can be carried out independently without resorting to a mechanic. The car must first be jacked up to remove the rim and wheel bolts. It will then be possible to remove the brake caliper. At this point, using a suitable screwdriver, all that remains is to remove the caliper bracket with the brake pads inside. The bolts that hold the bracket firmly to the hub will then be unscrewed and only the brake discs to be replaced will remain.
Posted on 3 September 2023 by ScegliAuto
Replacement discs and rear pads
Mercedes Classe S (1991-1998 / MK 3, W140) Raise the car on a lift and remove the rear wheel. Using a pin punch of the appropriate diameter, first extract the upper pin fixing the pads, remove
How do you change the brightness of the Mercedes S-Class display?
Mercedes Classe S (2013-2020 / W222, MK 6) In order to change the brightness of the Mercedes S-Class display, two different input commands must be used: to change the brightness of the instrum
How to change the time on the Mercedes S-Class
Mercedes Classe S (2013-2020 / W222, MK 6) These short and simple instructions will show us how to change the time on the display of the Mercedes S-Class. First of all, we get into the car and Other guides that may interest you
|
How to reset the oil service in the Fiat Toro?In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.062
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |