Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Classe S
    4. : Brake pads replacement

Mercedes Classe S - Video tutorial

Model: Mercedes Classe S MK 3, W140 - Years 1991-1998
Part: Brake discs
Operation: Brake pads replacement

The efficiency of the braking system is essential to ensure the safety of the driver, passengers and other motorists. The guide below explains the basic steps to replace the brake pads. First the car must be lifted with a jack, then the rim must be removed, after having unscrewed the wheel bolts. Then the Allen screws that hold the caliper fixed to the hub must be unscrewed. Once the Allen screws have been removed, the caliper can be removed from the disc without detaching it from the braking system pipes. Furthermore, to extract the worn pads, it will be advisable to press on them, levering from the outside in the space between them and the caliper.


Posted on 13 September 2023 by ScegliAuto



Replacement discs and rear pads
Mercedes Classe S (1991-1998 / MK 3, W140) Raise the car on a lift and remove the rear wheel. Using a pin punch of the appropriate diameter, first extract the upper pin fixing the pads, remove
How to change the brake discs of your car
Mercedes Classe S (1991-1998 / MK 3, W140) The following guide shows you step by step how to best replace the brake discs in your car. These are of primary importance so that your vehicle alwa
Rear shoe replacement instructions
Mercedes Classe S (1991-1998 / MK 3, W140) To replace the rear shoes, proceed as follows: lift the car and remove the rear wheel and then unscrew the fixing pins of the caliper and its support

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos