Do it yourself
Frequently asked questions about cars and motorcycles

Replacing the Rear Hatch Button

Model: Mercedes Classe E W211 - Years 2002-2009
Part: Push button

This brief tutorial shows how to remove the hatch button from your car. Remove the 2 screws with a Torx screwdriver located in the handle of the hatch and also the covers to access the lights. You will need to remove the panel by lowering one side at a time, locating the clips, and pulling at that point, giving it a good tap if necessary. Next, release the clips holding the electrical connector of the button, pulling out the connector and disconnecting the electrical plug. You can then pull out the button, being careful not to damage the rubber gasket.

Updated on 21 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Mercedes Classe E (2002-2009 / W211) Lift the trunk lid and use a plastic trim tool to remove the side clips as shown in the first image of the video. Repeat the same operation using a s…
Mercedes Classe E (2002-2009 / W211) Replacing the license plate light bulb (which is of the bulb type) is done very quickly: open the trunk and lift it enough to access the lamp holder …
Mercedes Classe E (2002-2009 / W211) You may experience a problem with the trunk opening on your car. Try removing the inner cover of the hatch and check for any issues, possibly with th…

How to Open a Stuck Boot on the Peugeot 407?

On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open.

Watch the video!


by ScegliAuto

More videos