Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Gl
    4. : How to change the front brake discs and pads on Mercedes GL

Mercedes Gl - Video tutorial

Model: Mercedes Gl MK 1, X164 - Years 2006-2012
Part: Brake discs
Operation: How to change the front brake discs and pads on Mercedes GL

To replace the front brake discs and pads on this car model, it is advisable to lift it on a bridge and remove the front wheel; then disconnect the wear sensor socket first from the pads and then from the relative wiring; then remove the protective caps of the calliper fixing pins and disassemble it and then remove the old pads; proceed with disassembling the caliper support and then the screw fixing the disc to the hub; brush and grease the disc seat before installing the new one, cleaning it from the protective oil; we will then proceed backwards to assemble the new pads.


Posted on 16 September 2023 by ScegliAuto



Replacement discs and rear pads
Mercedes Gl (2006-2012 / MK 1, X164) If the rear brake discs have to be replaced, it is a good idea to replace the pads as well; therefore lift the car and remove the rear wheel, release
Replacement discs and front pads
Mercedes Gl (2006-2012 / MK 1, X164) Raise the car on the bridge and remove the front wheel; remove the pad support spring, the brake caliper fixing pin caps to be able to disassemble it
How to remove the front bumper of the Mercedes ML - GL
Mercedes Gl (2006-2012 / MK 1, X164) Let's see in this guide the main instructions to remove and replace the front bumper of the Mercedes ML, but also of the GL. First of all, we open th

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos