Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Open the Bonnet of the Mini Cooper

Model: Mini Mini R56, R55, R57 - Years 2007-2014
Part: Body

To open the engine compartment bonnet on the Mini Cooper, first locate the lever inside the cabin. You can find it on the driver's side, positioned low on the left, near the hinge of the door. At this point, pull the lever to open the bonnet. Now, to lift the bonnet and gain access to the engine compartment, you need to find a small lever to press with your fingers, located under the front perimeter of the bonnet, slightly to the right (as shown in the images). Once found and pressed, you can lift the bonnet. Job done!

Updated on 12 March 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Open the Bonnet of a Mini Cooper
How to Open the Bonnet of a Mini Cooper
Mini (2007-2014 / R56, R55, R57) Start by opening the driver's front door of your Mini Cooper by pulling the opening handle. Next, pull the handle located near the door hinge twice. …
How to Open the Bonnet of the Mini Cooper
How to Open the Bonnet of the Mini Cooper
Mini (2001-2007 / R53, R52, R50) In this short video, follow these simple steps to open the bonnet of the Mini Cooper. First, open the front door and pull the lever located under the…
How to Open the Bonnet of the Mini Cooper
How to Open the Bonnet of the Mini Cooper
Mini (2017-2023 / Countryman2, F60) .. In this short and simple guide, you will learn how to open the bonnet of the Mini Cooper, following the instructions below. First, open the front door.. …

    Frequently Asked Questions

    • Mini 2007-2014 - How to open the bonnet on a Mini Cooper when the cable is broken? Read answer
    • Mini 2007-2014 - What to do when the hood of the Mini Cooper does not open? Read answer

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos