Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installing an Anti-Roll Bar

Model: Mini Mini R53, R50, R52 - Years 2001-2007
Part: Anti-roll bar

Installing the anti-roll bar is very simple: it should be applied to the supports of the front shock absorbers. Once you open the front bonnet, remove two fixing nuts from the inner shock absorber supports, position the anti-roll bar by aligning the holes of the plates with the studs of the supports, and tighten the nuts you previously removed. If necessary, adjust the width of the bar to prevent any play at the stud pins. The bar will provide the chassis with greater torsional stiffness, improving road holding.

Updated on 7 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Rear Bicycle Carrier Installation
Rear Bicycle Carrier Installation
Mini (2010-2016 / R60, Countryman1) The vehicle is already prepared to accommodate the bicycle carrier accessory, which is very simple and quick to install. Obtain the original bicycle …
How to install the steering wheel spacer on a Mini Cooper S.
How to install the steering wheel spacer on a Mini Cooper S.
Mini (2001-2007 / R53, R50, R52) In this video, we see how to install the steering wheel spacer on a Mini: first, we disconnect the negative pole of the battery. Using a flathead scr…
How to Install an Additional Control Unit
How to Install an Additional Control Unit
Mini (2010-2016 / R60, Countryman1) In the following video, we can observe how to proceed with installing an additional control unit on a Mini diesel engine. This simple operation will …

BMW E90 E91 E92 E93: Replace Front Window Regulator

Replacing the front window regulator for BMW E90, E91, E92, and E93 models follows a similar procedure for all these versions of the Anglo-German automaker's vehicles. First, obtain a flathead screwdriver to remove the inner door panel. You need to take off the cover of the armrest structure that is snap-fitted. After that, you can reconnect the wiring and screw everything back in place. Finally, reinstall the panel and insert the window glass into the structure. Having someone assist you will make the process easier.

Watch the video!


by ScegliAuto

More videos