Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Engine Cylinder Head of a Mini

Model: Mini Mini R56, R57, R55 - Years 2007-2014
Part: Cylinder head

Do you want to remove the engine cylinder head of your Mini? Let's see how to do it. Pull the lever to open the engine compartment located at the bottom left of the dashboard and lift the front bonnet, securing it. The coils are located near the plastic engine cover. Lift the plastic clip and disconnect the power cable. Grasp the coil with your hands and rotate it to the right and then to the left until it comes out of the cylinder head. Disconnect all coils and power connectors. Unscrew the cylinder head bolts, then remove the cover from the engine block. Compare the two pieces as shown in the video and reassemble the piece by following the various steps in reverse.

Updated on 25 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Mini Cooper cylinder head disassembly
Mini Cooper cylinder head disassembly
Mini (2001-2007 / R52, R50, R53) Let's see today the main instructions that will allow us to disassemble and replace the cylinder head of the Mini Cooper. First we open the bonnet of…
How to remove the cylinder head of a Mini Cooper
How to remove the cylinder head of a Mini Cooper
Mini (2001-2007 / R52, R50, R53) Before we begin, we will need to open the hood and make sure the engine is cold. If this is not the case, we will have to wait for it to cool down. T…
Replacement of the timing chain of the Mini Cooper.
Replacement of the timing chain of the Mini Cooper.
Mini (2007-2014 / R56, R57, R55) In this guide, we will see the process of how to disassemble and replace the timing chain of the Mini Cooper. First, we open the engine hood of our c…

Other guides you may be interested in

How to Remove the Armrest on the Centre Tunnel of a Volkswagen Golf

Let’s see how to remove the armrest on the centre tunnel of a Volkswagen Golf. Unscrew the securing screws (located inside the cup holder) with a screwdriver; use a plastic lever to pry off the cover at the rear of the centre tunnel (air vents). After removing the plastic cover, unscrew the securing bolts in the centre armrest using a socket wrench. Once this is done, pull off the tunnel and disconnect any power cables. Finally, insert the new part into the centre tunnel, and reassemble all components of the glove compartment as previously disassembled.

Watch the video!


by ScegliAuto

More videos