Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Reversing Light Bulb on a Mitsubishi Pajero

Model: Mitsubishi Pajero MK 2, V20 - Years: 1991, 1992, 1993, 1994, 1995, 1996, 1997, 1998, 1999
Part: Tail light bulb

See other generations:
Video tutorial

Before you can begin, open the tailgate of the luggage compartment on your Mitsubishi Pajero. Start by unscrewing and removing the screws that hold the rear light unit in place.

Once done, extract the light unit from its housing. This will give you access to the rear cover of the blown reversing light bulb.

Proceed to unclip the bulb cover, then release the securing clip and disconnect the corresponding connector. Once this last step is complete, you can remove the bulb, finishing the disassembly.

To install the new bulb and reassemble the light unit, simply follow these instructions in reverse, and the replacement will be complete.


Updated on 5 April 2026 by ScegliAuto


Related tutorials

Guide to Replacing the Reverse Switch on the Mitsubishi Pajero 3.5L
Guide to Replacing the Reverse Switch on the Mitsubishi Pajero 3.5L
Mitsubishi Pajero (1991-1999 / MK 2, V20) In this brief and simple guide, you will learn how to remove and replace the reverse switch on the Mitsubishi Pajero with a 3.5-litre engine. First, …
How to Change the Headlamp Bulb on a Mitsubishi Pajero 3
How to Change the Headlamp Bulb on a Mitsubishi Pajero 3
Mitsubishi Pajero (1999-2006 / V60, MK 3) In this video, see how to remove and replace the headlamp bulb on a Mitsubishi Pajero third series, following the instructions below. First, open the…
How to replace the front headlight bulb of the Mitsubishi Pajero
How to replace the front headlight bulb of the Mitsubishi Pajero
Mitsubishi Pajero (1999-2006 / V60, MK 3) Today we will discover the instructions on how to disassemble and replace the low beam bulb of the front headlight of the Mitsubishi Pajero. First, w…

How to Reset the Tire Pressure Light on a MG ZS?

On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward.

Watch the video!


by ScegliAuto

More videos