Do it yourself
| ||||
|
Nissan Pathfinder - Video tutorial
Model: Nissan Pathfinder
R51, MK 3
- Years 2005-2012 Place the car on the jack by lifting the desired wheel. Unscrew the 6 wheel nuts and remove the wheel assembly from the hub. Loosen and then remove the fasteners holding the protective plate and the brake caliper piston in order to access the pads. Remove the worn outer pad and place it close to the piston, keeping both inside the tool you will use to mechanically retract the piston; remove the worn inner pad from the surface of the disc and place the two new friction elements in the housing on the left and right of the brake disc respectively. Subsequently, reposition the plate with the piston attached in its seat, tightening it with the two stops, making sure that there are no abnormal movements or play of the brake unit. Finally, reposition the wheel on the hub and tighten the 6 wheel nuts. Finally, lower the jack bringing the car back to the road level.
Posted on 26 June 2023 by ScegliAuto
This video is currently unavailable
Replacement of front brake pads
Nissan Pathfinder (1986-1995 / MK 1, Wd21) Raise the car on suitable car stands and remove the front wheel; then unscrew the fixing pins of the brake caliper, remove it from its seat, remove t
Replacement of rear brake pads
Nissan Pathfinder (2005-2012 / R51, MK 3) First loosen the wheel nuts, then we proceed to lift the car and make it safe. Disassemble the wheel and carefully disassemble the caliper by removin
Replacing the front brake pads.
Nissan Pathfinder (1986-1995 / MK 1, Wd21) First of all remove the front wheel with the suitable wrench. Perform the bolt unlocking phase with the car normally resting on the ground. Then, lif Other guides that may interest you
|
How to reset the oil service in the Fiat Toro?In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.064
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |