Do it yourself
| ||||
|
Nissan Micra - Video tutorial
Model: Nissan Micra
K11
- Years 1992-2002 Before lifting the car, it is advisable to remove the safety split pin from the central axle shaft nut and to loosen the nut itself as well as the wheel fixing pins. At this point, lift the car and proceed with the disassembly of the pins that secure the shock absorber to the hub support; then extract the hub from the drive shaft. Remove the boot clamps, move it backwards and extract the CV joint from the shaft (it is fixed by forcing with a snap ring). Insert the new boot on the axis; apply grease to the inside of the joint and fit it onto the shaft itself; then position the cap and secure it with the clamps (better if you use the metal ones rather than the plastic ones). Then reassemble the drive shaft in the hub and the hub itself (apply a new split pin).
Posted on 16 July 2023 by ScegliAuto
How to extract the constant velocity joint of the Nissan Micra
Nissan Micra (1992-2002 / K11) In order to extract the constant velocity joint on the wheel side from the drive shaft, it is recommended to use the special tool that allows it to b
Rear wheel bearing replacement
Nissan Micra (2002-2010 / K12) Obtain replacement bearings. Raise the car, secure it and remove the wheel. Remove the metal protection that protects the sealing bolt placed on the
Localization and fuse diagram for Nissan Micra K12
Nissan Micra (2002-2010 / K12) In this video, we can see the fuse diagrams of the Nissan Micra K12, which are located in the passenger compartment, in a compartment that is situate Other guides that may interest you
|
How to reset the oil service in the Fiat Toro?In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.036
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |