Do it yourself
| ||||
|
Nissan Micra - Video tutorial
Model: Nissan Micra
K12
- Years 2002-2010 In order to replace the resistor of the passenger compartment fan of the Nissan Micra it is necessary to remove the panel which is located in the part immediately below the steering column. The panel will simply have to be disengaged by means of the special clips: a green connector will immediately be visible in its rear part. By unscrewing the torx screw under the connector, it will be possible to extract the resistor from its seat, which will be connected to the green connector. It will therefore be necessary to disconnect the old resistor from the connector and connect a new one, inserting it in the appropriate housing.
Posted on 22 February 2024 by ScegliAuto
Where is the heating resistor located in the Nissan Micra?
Nissan Micra (2002-2010 / K12) In this video we can see where the heating resistor is located in the Nissan Micra and how to proceed in case we need to replace it, an extremely sim
Interior fan resistor replacement
Nissan Micra (2002-2010 / K12) If it happens that some speeds of the passenger compartment ventilation fan do not work then there is a problem with the resistor that regulates its
How to remove the passenger compartment air fan of Nissan Micra k12
Nissan Micra (2002-2010 / K12) The guide shows how to replace the passenger compartment air fan motor of the Nissan Micra k12. To carry out this operation it is necessary to remove Other guides that may interest you |
Frequently Asked QuestionsHow to reset the oil service in the Fiat Toro?In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.047
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |