Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Nissan
    3. :
  3. Almera
    4. : Floor portion replacement

Nissan Almera - Video tutorial

Model: Nissan Almera N16, MK 2 - Years 2000-2008
Part: Bodywork
Operation: Floor portion replacement

To carry out this type of repair, it is necessary to have suitable equipment (to cut and weld the sheet metal) as well as a good familiarity in handling it. Once you have identified the portion of sheet metal to be replaced (if necessary make a cardboard template before removing it), trace the lines along which to perform the cut and proceed using a grinder wheel. With the piece removed (or the shape previously made) trace the contours on the piece of new sheet metal by cutting and shaping it appropriately (carry out several housing tests before welding it). Once you are sure of the shape of the new sheet, clean and sand the edges along which to perform the welding, first fix the piece with points and then proceed with the creation of the bead.


Posted on 9 August 2023 by ScegliAuto



Replacement of the timing chain of the Nissan Almera.
Nissan Almera (2000-2008 / N16, MK 2) Let's briefly go over the main instructions useful for replacing the timing chain of the Nissan Almera. First, we open the engine hood of our car and
Replacing the tappet cover gasket
Nissan Almera (2000-2008 / N16, MK 2) Failure of the tappet cover gasket is a fairly frequent defect and causes oil to escape which then stains the whole engine, also generating bad smell
How to change the air filter on a Nissan Almera.
Nissan Almera (2000-2008 / N16, MK 2) If we need to replace the engine air filter on this car, below we will find all the steps and necessary information for the replacement and we can al

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos