Do it yourself
| ||||
|
Nissan Micra - Video tutorial
Model: Nissan Micra
K11
- Years 1992-2002 The first thing to do is to place the vehicle on a lift and lift the vehicle, or use a hydraulic jack and place safety stands under the vehicle; next step we have to take a special wrench to unscrew the filter and loosen the oil filter, continue to unscrew the filter manually; place a container for used oil under the oil filter; once we have removed the oil filter we must place it inside the container, replace the old filter with the new one and screw it on. Unscrew the oil drain plug using a No. 14 combination wrench, place a waste oil container under the oil drain plug and wait for all the oil to drain out. Place the drain plug and tighten it using the #14 wrench. Clean the plug and insert a new O-ring. Lower the vehicle and top up the engine oil using a funnel to make this easier.
Posted on 9 December 2022 by ScegliAuto
Nissan Micra engine oil replacement 2
Nissan Micra (2002-2010 / K12) In this video tutorial we will see how to go about replacing the engine oil and oil filter in a Nissan Micra second series. First we go to open the b
How to replace the oil filter and engine oil in the Nissan Micra.
Nissan Micra (2002-2010 / K12) In this video tutorial, we can see how to replace the oil filter and how to top up the engine oil in the Nissan Micra, following a few simple steps:
How to do the service on the Nissan Micra?
Nissan Micra (1992-2002 / K11) We are following the instructions of the YouTuber to do a DIY service on our Nissan Micra K11. We start by draining the old oil from the engine. We p Other guides that may interest you
|
How to reset the oil service in the Fiat Toro?In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.054
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |