Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Nissan
    3. :
  3. Qashqai
    4. : How to install a new antenna in a Nissan Qashqai.

Nissan Qashqai - Video tutorial

Model: Nissan Qashqai J11 - Years 2014-2022
Part: Antenna
Operation: How to install a new antenna in a Nissan Qashqai.

In this video tutorial we are going to see how you can install a new antenna in a Nissan Qashqai (adhesive shark fin). The material we need: the new antenna, a spatula and fishing line, an 8 mm wrench. To remove the double-sided tape, we need to take the nylon thread (fishing) and insert it under the antenna, now let's pull and force slightly to remove the double-sided tape. After a few minutes, the antenna should come off, at this point we have to unscrew the cable with an 8mm key. Then let's clean the seat where the new antenna is to be installed. We put the double-sided tape under the new antenna, once the double-sided tape is in place, screw the bolt of the antenna cable and then attach the new antenna in place, then lean it slightly to see if it has been positioned correctly and then make it adhere.


Posted on 5 May 2023 by ScegliAuto

    Frequently Asked Questions

    • Qashqai 2006-2014 - How much does the Nissan Qashqai antenna cost? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos