Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Nissan
    3. :
  3. Qashqai
    4. : How to install shark fin antenna on Nissan Qashqai?

Nissan Qashqai - Video tutorial

Model: Nissan Qashqai J11 - Years 2014-2022
Part: Antenna
Operation: How to install shark fin antenna on Nissan Qashqai?

Before installing the new shark fin antenna we have to remove the old one. We do this by unscrewing the rod but leaving the base in place. We clean the bodywork in the antenna area or, even better, take the opportunity to wash the whole car and then connect the new antenna to the remaining installed base, as shown in the video. Make sure you tighten the screw that acts as the locking pin well. We can now remove the protective film from the base of the new shark fin antenna and proceed with its installation by applying good pressure with our hands to allow the adhesive to adhere adequately to the bodywork.


Posted on 4 April 2023 by ScegliAuto

    Frequently Asked Questions

    • Qashqai 2006-2014 - How much does the Nissan Qashqai antenna cost? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos