Do it yourself
Frequently asked questions about cars and motorcycles

How to Replace the Battery in a First Generation Nissan Qashqai

Model: Nissan Qashqai J10 - Years 2006-2014
Part: Battery

In this tutorial, you will learn how to replace the battery in a first generation Nissan Qashqai by following these simple steps: first, get inside the vehicle, turn off the engine, and pull the handbrake. Lift the bonnet and secure it with the prop rod. The battery is located on the right side of the engine compartment. To remove the battery, unscrew the support bar using a 10mm socket to loosen the two securing bolts. Once the bolts are removed, take out the support bar. Disconnect the negative terminal first (do not start with the positive terminal, as the entire vehicle is connected to the negative terminal; this could create dangerous sparks for the car's electrical system); use a 10mm spanner for this. Once the cable is disconnected, keep it well away for safety reasons. After both battery terminals are removed, you can take the battery out of its housing. Scrape the inside of the terminals with sandpaper to remove any white oxide that could cause long-term issues. Apply copper grease to the terminals of the new battery to improve cable contact and limit oxidation. Install the new battery and connect the positive terminal first, followed by the negative.

Updated on 8 August 2026 by ScegliAuto

Video tutorial

Related tutorials

Nissan Qashqai (2006-2014 / J10) In this mini guide for all Nissan Qashqai first series (2010) owners, discover how to replace the battery located inside the key. First, obtain two s…
Nissan Qashqai (2006-2014 / J10) In today's video, see how to replace the battery (CR2016) in the key fob of a Nissan Qashqai, model J10, produced from 2006 to 2014. Start the proced…
Nissan Qashqai (2014-2022 / J11) In this video tutorial, you will learn how to disassemble and replace the battery in the remote key for a second-generation Nissan Qashqai. First, ta…

Other guides you may be interested in

How to Open a Stuck Boot on the Peugeot 407?

On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open.

Watch the video!


by ScegliAuto

More videos